Wissensdatenbank: Hersteller > BlueCoat > PacketShaper
Factory Default PacketShaper
Gepostet von Daniel Riediger, Last modified by Daniel Riediger an 18 April 2011 12:57
You can reset PacketShaper in the command-line or browser interface. This action resets the unit's IP address to, making it unreachable on your network until it is reconfigured using Guided Setup.Resetting in the CLI

1. Access the CLI.
2. Type setup reset all.

Resetting in the Browser Interface

1. Click the setup tab.
2. From the Choose Setup Page list, choose unit resets.
3. Click Reset All.
(4 Stimme(n))
Nicht hilfreich

Kommentare (0)